Plumbing, Gas & Mechanical Services

Fourteen services across five pillars — from a single blocked drain to a contracted maintenance program, delivered to commercial standard on sites of any size.

Plumbing & Drainage

General plumbing and drainage for homes, tenancies and whole sites — reactive repairs, fault-finding, and the underground work that keeps a property functioning.

  • General Plumbing
  • Blocked Drains
  • Septic System, ATU's
  • Storm-water Systems
  • Water Filtration Systems

Blocked drains are cleared with high-pressure jetting and drain machines, then inspected on CCTV so you see the cause rather than just the symptom. Stormwater covers pits, soakwells and site drainage. Septic systems and aerated treatment units are installed and serviced for properties outside the sewer network.

Kitchenette plumbing — under-sink trap, macerator and waste alongside the hot water plant.
Four-unit commercial gas hot water plant wall with insulated flow, return and natural gas pipework.

Gas & Hot Water

Natural gas and LPG, installed and serviced under gas fitting licence GF 17656, alongside hot water from a single domestic unit through to a commercial bank.

  • Natural Gas & LPG Installation and Servicing
  • Hot Water Solutions
  • Emergency Plumbing & Gas

LPG is treated as its own discipline — cylinder installations, changeover regulators and appliance connections for properties off the natural gas network. Hot water covers storage and instantaneous units, heat pump and solar, commercial heater banks, and tempering and TMV work where delivered temperature has to be verified.

Maintenance & Compliance

Run as a contracted program rather than a series of call-outs: an asset audit and register, a service calendar, compliance testing at statutory intervals, and condition and budget reporting.

  • Planned Preventive Maintenance
  • Back-flow Prevention Device Testing, Installation & Repairs
  • Grease Trap Servicing & Installation
  • Fire Services

Backflow work covers RPZD and double check valve assemblies, with the device matched to the hazard rating of the connection and tested at the required interval. Fire services are inspected and tested against AS 1851 intervals. Grease traps are serviced to the trade waste permit conditions and the pump-out frequency set for the site.

Backflow prevention assemblies installed behind protective bollards at a commercial site boundary.
Fire sprinkler mains run through an office fit-out ceiling space.

Construction & Projects

Construction plumbing for new builds, renovations, office fit-outs and civil works, staged the way a head contractor’s program expects.

  • Construction

Staged in-ground, rough-in, fit-off, commissioning and handover — with the documentation that gets a trade through a tender and off a defects list: SWMS, ITPs, as-builts and certification.

Mechanical & HVAC Services

Mechanical services pipework, held alongside plumbing, gas and backflow — a combination most plumbing contractors do not carry.

  • HVAC Mechanical Services

Chilled and heating hot water pipework, condensate, cooling tower and make-up water, plant room pipework, pumps and valves.

Plant room mechanical services — air handling units, copper heating hot water pipework and plant control panel.

All fourteen services

  • General Plumbing
  • Emergency Plumbing & Gas
  • Blocked Drains
  • Septic System, ATU's
  • Hot Water Solutions
  • Natural Gas & LPG Installation and Servicing
  • Construction
  • Planned Preventive Maintenance
  • Back-flow Prevention Device Testing, Installation & Repairs
  • Grease Trap Servicing & Installation
  • Water Filtration Systems
  • Storm-water Systems
  • Fire Services
  • HVAC Mechanical Services

Sectors we work in

  • Residential
  • Commercial
  • Industrial
  • Civil
  • Retail
  • Aged Care
  • Hospitality
  • Medical & Health Care

Tell us what the job is.

A one-off repair, a fit-out package or a maintenance program — send the scope through and we will come back with a clear price.

Request a QuoteSee our work